2320-01-318-9902 EIC:B5C, VOLUME NO. 2">
Ensure solder flows evenly on both
ends of wire.
(11) Twist bare ends of wires (1 and 4)
together and solder.
Allow solder to cool before handling.
Failure to comply may result In Injury
(12) Slide heatshrink tubing (3) over solder
Never use open flame to apply
heat to heatshrink tubing. Failure
to comply may result in injury to
Allow heatshrink tubing to cool
comply may result in injury to
Do not overheat heatshrink tubing.
Tubing may split or melt if too much
heat is applied.
Ensure solder joint is centered in
(13) Apply heat to heatshrink tubing (3). Allow
tubing to shrink until tight on solder joint
and insulation of wire (1).
(14) Repeat steps (7) thru (13) for other solder
|Integrated Publishing, Inc.|