 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-360-20-2
b. Type 2 Connector Repair
(1) Remove two screws (1) and cable clamp
(2) from connector (3).
(2) Remove heatshrink (4) from wires (5).
(3) Remove wire (5) and terminal (6) from
connector (3).
NOTE
Make cut directly behind damaged
terminal.
(4) Cut and remove terminal (6) from wire (5).
Remove 0.25 in. (0.635 cm) of insulation
(7) from end of wire (5). Discard terminal.
(5) Install new terminal (6) on wire (5) and
crimp in place.
(6) Install terminal (5) on connector (3).
(7) Install heat shrink (4) around wires (5).
(8) Install cable clamp (2) on connector (3)
with two screws (1).
c. Type 3 Connector Repair
NOTE
Make
cut
directly
behind
damaged terminal.
If wire is too short after trimming,
refer to TM 43-0158.
(1) Cut and remove terminal (1) from wire (2).
Remove insulation (3) from end of wire (2)
equal to dimension A. Discard terminal.
NOTE
Ensure all strands of wire are inside
terminal when installing.
(2) Install new terminal (1) on wire (2).
7-281
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
|
|
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
|
Click
here for thousands of PDF manuals
