 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-360-20-2
CAUTION
Do not allow fan to strike radiator
during removal. Damage to radiator
may result.
(5) Remove
four
screws
(14)
and
lockwashers (15) from fan (16) and fan
clutch (17). Discard lockwashers.
CAUTION
Spacer must be held in place or
caught as fan is removed. Spacer
can fall off and be damaged.
(6) Pull fan (16) and spacer (18) away from
fan clutch (17) with aid of assistant.
(7) Set fan (16) down gently on bottom of
radiator (13) inside fan shroud (19) with
aid of assistant.
(8) Loosen four fan clutch mounting screws
(20).
(9) Loosen adjusting screw (21) and lower fan
clutch (17) on mounting bracket (22).
(10) Remove fan belts (23) from fan clutch (17)
and crankshaft pulley (24).
c. Installation
CAUTION
Arctic kit belts must be installed if
temperatures below -37F (-38 C) are
expected. Arctic kit belts should not
be used if temperature is continually
above 80 F (27C). Failure to comply
may result in shortened belt life.
(1) Install fan belts (1) on crankshaft pulley (2)
and fan clutch (3).
(2) Turn adjusting screw (4) clockwise to
tighten fan belts (1).
(3) Check that fan belt (1) tension is 70-90 lb
(310-400 N) using bell tension gage (5).
(4) Tighten four screws (6) securing fan clutch
(3) to mounting bracket (7). Torque to 80
lb-ft (108 Nm).
(5) Position spacer (8) and fan (9) on fan
clutch (3) with aid of assistant.
(6) Install four new lockwashers (10) and
screws (11) through fan (9) into fan clutch
(3). Torque to 80 lb-ft (108 Nm).
6-55
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
|
|
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
|
Click
here for thousands of PDF manuals
