 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-285-24-2
4-4. TRANSMISSION (CONT)
j. Control Valve Assembly (cont).
STEP
LOCATION
ITEM
ACTION
REMARKS
REASSEMBLY
NOTE
Check position of all valves, springs, plugs and other parts before installation. Install all spring adjusting
rings (15, 16, 17, 18, and 19) in positions they held before disassembly. If necessary to achieve original
positions, use valve body adjusting ring tool. Other- wise, transmission will not operate properly. All
valves, when dry, should move freely in their bores. Refer to illustration on following page for valve bore
positions. Control valve body (2) is shown flat side down.
17
Bore A
a
Valve (61)
Install
b
Spring (60)
Install
c
Valve stop pin
Position
(59), washer
(58), and
spring adjust-
ing ring (16)
d
Retainer pin
Install
Depress spring adjusting ring
(11)
(16). Retainer pin (11) must
go through valve stop pin
(59) and retain spring ad-
justing ring (16)
18
Bore B
a
2-3 shift valve
Install
Shorter land first
(65)
b
2-3 modulator
Install
Smaller end first
valve (64)
c
2-3 shift spring Position
(63), valve
stop (62),
and spring
adjusting
ring (17)
d
Retainer pin
Install
Depress spring adjusting ring
(12)
(17). Retainer pin (12) must
go through valve stop (62)
and retain spring adjusting
ring (17)
19
Bore C
a
3-4 shift valve
Install
Smaller end first
(69)
4-113
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals