INSPECTION (cont) - TM-9-2320-285-24-20511

TM 9-2320-285-24-2

4-4.

TRANSMISSION (CONT)

Main Shaft and Gear Unit Assembly (cont).

STEP

LOCATION

ITEM

ACTION

REMARKS

INSPECTION (cont)

ness gage between carriers

(cont)

(30, 36, and 42) and thrust

washers (32, 38, and 44).

End play must be within

0.008-0.031 inch. If you

notice any defective condi-

tions, replace part. Repl ace

entire pinion set (28, 34,

and 40) if any individual

pinion is damaged. Refer to

steps 10 and 11.

Bearing assembly Inspect

Inspect for roughness or bind-

(14)

ing in operation

Inspect

for worn, galled, or bent

condition. If you notice any

of these conditions, replace

part

Two spring pins

Inspect

Inspect for worn, bent or

(9)

broken condition. Replace if

necessary. Refer to step 2

Two bushings

Inspect

Inspect for galling, scratches

(11)

or other wear. Replace if

necessary. Refer to step 3

Lube orifice

Inspect

Inspect for worn, bent or

plug (22)

broken condition. Replace if

necessary. Refer to step 6

All other parts

Inspect

Inspect for worn, bent or

broken condition. Closely

examine all gear teeth for

any damage. Replace part if

necessary

REASSEMBLY

NOTE

If the front, center, or rear planetary carrier assemblies (6, 18, or 26) were

not disassembled, start with step 17. Otherwise start with steps 14

through 16 for reassembly of any planetary carrier assemblies that were

disassembled.

4-30