DISASSEMBLY (cont) - TM-9-2320-285-24-20489

TM 9-2320-285-24-2

4-3.

TORQUE CONVERTER (CONT)

STEP

LOCATION

ITEM

ACTION

REMARKS

DISASSEMBLY (cont)

NOTE

Don't disassemble stator assembly (21) unless replacement of washers

(34 and 35) or rivets (36) is

Stator

Rivets (36)

Remove

assembly

(21)

Place stator assembly on drill press,

formed rivet side up. Drill rivets,

removing formed heads, using 3/8

inch drill. Place stator rivet base

under stator assembly (21), as

shown, and top plate on top. Be

sure that holes in stator rivet base

are under rivets. Install capscrew

to hold plates together. Tighten to

60 pounds foot. Place removing,

in- stalling and swaging fixture on

hydraulic press.

Install rivet

removing pin into re- moving,

installing and swaging fixture head

and tighten retainer thumb screw.

Place stator assembly (21) drilled

rivet side up. Press rivets (36) from

stator assembly (21) with rivet

removing pin. Remove removing,

in- stalling and swaging fixture,

capscrew, top plate, and stator rivet

base

Washers (34,

Remove

35, 37 and

38), cam (39)

and stator

(40)

WARNING

Do not strike hardened steel pieces with steel hammer. Metal chips could

cause serious injury to your eyes. Seek medical attention immediately if

you get metal chips in your eyes. Always wear safety goggles when

hammering.

4-8