 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-285-24-2
3-17. TRANSMISSION MAINTENANCE (CONT)
d. Torque Converter (cont).
STEP
LOCATION
ITEM
ACTION
REMARKS
REMOVAL
1
Torque con-
a. Torque con-
Position
verter (1)
verter lifter
b. Two nuts (2)
Install
c. Torque con-
Lift off using hoist attached to ring in
verter (1)torque converter lifter. Lift straight up
and remove to table
d. Two nuts (2)
Remove
e. Torque con-
Remove
verter lifter
INSTALLATION
NOTE
Before installing torque converter (1), be sure that oil seal (3) is lubricated with oil-soluble grease and is seated in its
groove in oil pump hub.
2
Torque con-
a. Torque con-
Position
verter (1)
verter lifter
b. Two nuts (2)
Install
3
Front of
Torque converter
Install using hoist attached to ring in
transmis-
(1)
torque converter lifter. Lower onto trans-
sion
mission while rotating to engage flats on
torque converter hub with flats in trans-
mission oil pump. Also, splines of turbine
hub (inside torque converter) must engage
splines of transmission turbine shaft.
When seated, measure distance from trans-
mission mounting flange to torque convert-
er cover, as shown. If distance is greater
than required 9/16 inch raise torque con-
verter, rotate to align pump hub f lats,
and reseat. Then remove torque converter
lifter
3-120
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals