 |
|||
|
|
|||
|
Page Title:
Hood and Latch and Rear Enclosure |
|
||
| ||||||||||
|
|
 TM 9-2320-285-24-1
2-65.
BODY AND CAB MAINTENANCE (CONT)
f.
Hood and Latch and Rear Enclosure.
This task covers:
a. Removal
c.
Installation /Repair
b. Cleaning
e.
Adjustment
d. Inspection
INITIAL SETUP:
Tools
Personnel Required
No. 1 Common Organizational Maintenance
Wheel Vehicle Mechanic MOS 63B
Tool Kit
Socket wrench set, 3/8 inch drive
Equipment Condition
Open end wrench set
Paragraph
Condition Description
Scratch wire brush
Cross tip screwdriver set
Vehicle parked on level
Safety glasses
surface, engine off, and
Retaining ring pliers
parking brake applied.
Air compressor
2-69c
Windshield washer pump and
reservoir removed.
Materials/Parts
2-30
12-volt and 24-volt
Cleaning solvent
Item 1, Appendix C
receptacles removed from rear
Clean cloths
Item 2, Appendix C
hood enclosure.
Detergent
Item 27, Appendix C
STEP
LOCATION
ITEM
ACTION
REMARKS
REMOVAL
1
Cab deck,
a. Two latches
Unlatch
Pull up and disengage from
hood (4)
(11)
latch brackets (7)
b. Hood (4)
Open
Raise up and rest against
side of cab
c. Seven capscrews
Remove
(1), locknuts
(2), and
washers (3)
d. Hood (4)
Remove
NOTE
Don't perform steps 1e and 1f below unless inspection indicates removal/replacement of latch
assemblies (7 thru 11 and 14) is necessary.
e. Four screws (5)
Remove
Support latch brackets (7)
and locknuts
(6)
f. Two latch
Remove
brackets (7)
2-721
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals