Rear Cab Guard and Heat Shield

TM 9-2320-285-24-1

2-65.

BODY AND CAB MAINTENANCE (CONT)

Rear Cab Guard and Heat Shield.

This task covers:

a. Removal

Inspection/Repair

b. Cleaning

Installation

INITIAL SETUP:

Tools

No. 1 Common Organizational Maintenance

2-53a

Trailer brake lines and

Tool Kit

couplings disconnected and

Socket wrench set, 1/2 inch drive

removed from rear cab guard.

Open end wrench set

2-65c

Rear platform removed.

Safety glasses

2-13c

Primary and secondary fuel

Chain hoist

filters removed.

Welding shop equipment

2-15b(2)

Coolant filter removed.

Air compressor

2-41e

External transmission oil

10 gauge metal, 2 inches by 11 inches

filter removed.

2-58b

Power steering hose clamp

Materials/Parts

removed.

Cleaning solvent

Item 1, Appendix C

2-58c

Power steering reservoir

Clean cloths

Item 2, Appendix C

removed.

2-31g

Rear flood light removed.

Personnel Required

3-24i

Tractor protection valve

Wheel Vehicle Mechanic MOS 63B

removed.

2-53b

Hose tender removed.

Equipment Condition

2-13b(1)

Fuel tank guard removed.

Paragraph

Condition Description

2-14b

Exhaust stack, muffler, and

brackets removed (rear cab

Vehicle parked on level

guard supported on right side)

surface, engine off, and

parking brake applied.

STEP

LOCATION

ITEM

ACTION

REMARKS

REMOVAL

Rear cab

Chain hoist

Attach

To top of rear cab guard (5);

guard (5),

take up chain slack

top

WARNING

Be sure chain hoist is securely fastened to rear cab guard (5) before performing the following

step. Failure to do so could cause serious injury due to rear cab guard falling on you. If you

are injured, obtain medical aid immediately.

2-709