Click here to make tpub.com your Home Page

Page Title: REPAIR (cont)
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

TM 9-2320-285-24-1
2-41. TRANSMISSION MAINTENANCE (CONT)
h.
Shift Lockout Cylinder, Lines, and Fittings (cont).
(1) Shift Lockout Lines and Fittings (cont).
STEP
LOCATION
ITEM
ACTION
REMARKS
REPAIR (cont)
WARNING
9
Dry cleaning solvent (P-D-680), used to clean parts is toxic and flammable.
Wear(cont)
protective goggles and gloves and use only in a well ventilated area. Avoid
contact with skin, eyes, and clothes and don't breathe vapors.
Do not use near
open flame or excessive heat and don't smoke when
using it. Failure to do so
could cause serious injury.  If
you become dizzy while using cleaning solvent, get
fresh
air
and medical attention immediately. If contact with skin or clothes is
made,
flush with large amounts of water. If contact with eyes is made, wash eyes
with water and seek medical aid immediately.
d. Connector
Clean
Use cleaning solvent P-D-680;
(10 or 16)
allow to air dry. Use wire
brush to remove all hose
residue from socket and
nipple of connectors
e. Hose (11)
Cut to proper
Use new hose; use old hose to
length
determine proper length
required. Cut hose square
using fine tooth hacksaw
f.
Connector
Place connector socket in vise as shown
(10 or 16)
g. Hose (11)
Screw hose counterclockwise into socket
until hose bottoms; back hose off 1/4 to
1/2 turn
h. Mandrel assem-
Oil nipple threads, mandrel assembly tool,
bly tool
and inside of hose liberally using hydrau-
lic oil. Tighten connector nipple and nut
on mandrel assembly tool. Apply oil to all
parts
i.
Connector
Screw nipple clockwise into socket and hose.
(10 or 16)
Allow 1/32 to 1/16 inch clearance between
nut and socket so nut will swivel. Remove
mandrel assembly tool from connector.
Remove connector from vise
NOTE
Repeat steps 9f thru 9i above to install remaining connector (10 or 16) on
hose (11).
2-472

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business