INSPECTION - TM-9-2320-285-24-10380

TM 9-2320-285-24-1

2-32.

SENDING UNITS AND SWITCHES MAINTENANCE (CONT)

e. Neutral Start and Backup Light Switches (cont).

STEP

LOCATION

ITEM

ACTION

REMARKS

INSPECTION

a. Electrical

Inspect

Replace if insulation frayed,

leads (9 thru

cut, or cracked or if con-

12)

ductor corroded or broken

b. Backup light

Inspect

Replace if cracked, broken,

switch (4)

or inoperative

and neutral

start switch

(7)

c. All other parts

Inspect

Replace if cracked, broken,

distorted, or threads

damaged

INSTALLATION

Cab, under

a. Four new elec-

a. Install,

Strip 1/2-inch insulation

hood

trical con-

if neces-

from lead; crimp securely

nectors (13)

sary

b. Connect

Push connectors with leads

into connector housing (1)

as tagged

b. Neutral start

Position

On shift quadrant plate;

switch (7)

align mounting holes

c. Two screws (5)

Install and

and locknuts

tighten

(6)

d. Backup light

Position

On shift quadrant plate;

switch (4)

align mounting holes

e. Two screws (2)

Install and

and locknuts

tighten

(3)

f. Connector

Connect

Plug into wiring harness

housing (1)

connector

g. New tie strap

Install

At location noted during

(8)

removal

ADJUSTMENT/TEST

NOTE

Neutral start switch should prevent use of engine starter unless shift lever is in neutral (N) position. If

starter will crank with shift lever in any other position, adjust neutral start switch as follows.

2-357