REMOVAL/DISASSEMBLY (cont) - TM-9-2320-285-24-10123

TM 9-2320-285-24-1

2-13.

FUEL SYSTEM MAINTENANCE (CONT)

d. Quick Start (cont).

STEP

LOCATION

ITEM

ACTION

REMARKS

REMOVAL/DISASSEMBLY (cont)

Air inlet

a. Tube (15)

Disconnect

housing,

and remove

right side

b. Atomizer (19)

Remove

Air clean-

a. Crimp connector

Remove and

Cut wires (23 and 30) as

er, left

(29)

discard close as possible to

side, rear

connector (29)

b. Two capscrews

Remove

(20) and

bracket (21)

c. Ether valve

Remove

(22)

d. Clip (34)

Remove

From cap (35) chain; route

chain through hole in

bracket (26) to remove

clip (34)

e. Cap (35)

Remove

Slip cap chain through hole

in bracket (26)

f. Two locknuts

Remove

(24), cap-

screws (25),

and bracket

(26)

g. Two capscrews

Remove

Support bracket (33)

(31) and

locknuts (32)

h. Bracket (33)

Remove

CLEANING

a. Ether valve

Clean

Wipe with clean, dry cloth

(22)

WARNING

Dry cleaning solvent (P-D-680), used to clean parts is toxic and flammable. Wear protective goggles and

gloves and use only in a well ventilated area. Avoid contact with skin, eyes, and clothes and don't breathe

vapors. Do not use near open flame or excessive heat and don't smoke when using it. Failure to do so

could cause serious injury. If you become dizzy while using cleaning solvent, get fresh air and medical

attention immediately. If contact with skin or clothes is made, flush with large amounts of water. If contact

with eyes is made wash eyes with water and seek medical aid immediately.

2-100