WINDSHIELD WASHER JET ASSEMBLY

TM9-2320-270-20-3

WINDSHIELD WASHER JET ASSEMBLY - CONTINUED

ACTION

REMARKS

ITEM

LOCATION

REMOVAL

NOTE

Except as noted, steps in this task are the same for both right and left windshield washer

jet assemblies. Right jet assembly is shown.

Using 9/32-inch wrench, unscrew and

Jet (2)

1. Jet fitting (1)

take out.

Pull off.

Hose (3)

If hose is brittle, replace it

(page 4-1).

With help from assistant and using 7/16-

Nut (5)

3. Jet fitting (1)

inch and 5/8-inch wrenches, unscrew and

to cowl (4)

take off.

Turn and take out.

Jet fitting (1)

4. Cowl (4)

a. Take off.

Gasket (6)

5. Jet fitting (1)

b. Get rid of.

CLEANING/INSPECTiON

WARNING

Drycleaning solvent P-D-680 is toxic and flammable. Wear protective goggles and

gloves and use only in a well ventilated area. Avoid contact with skin, eyes, and clothes

and don't breathe vapors. Do not use near open frame or excessive heat. The flashpoint

is 100F to 138F (38 to 59C). if you become dizzy while using cleaning solvent, get

fresh air immediately and get medical aid. if contact with eyes is made, wash your eyes

with water and get medical aid immediately.

a. Soak in solvent for at least 30 minutes.

Jet (2) and jet

fitting (1)

b. Using wire, clean out passges.

If passages are still plugged,

replace jet assembly.

c. Look for stripped threads and other

damage.

Replace if damaged.

INSTALLATION/ADJUSTMENT

Put on.

New gasket (6)

7. Jet fitting (1)

Turn and put in place.

Jet fitting (1)

8. Cowl (4)

4-1178