PUSHER AXLE AIRBRAKE CHAMBERS

TM9-2320-270-20-2

PUSHER AXLE AIRBRAKE CHAMBERS

This task covers:

c. Inspection/Replacement (page 4-696)

a. Removal/Disassembly (page 4-692)

d. Assembly/installation (page 4-697)

INITIAL SETUP

Materials/Parts

Tools

Soap, liquid (item 14, appendix C)

Chisel, cold hand, 1/2-inch

Tape, teflon (item 22, appendix C)

Drill, electric, portable

Drill twist, 1/8-inch

Personnel Required

Hammer, machinist's ball-peen, 1-pound

Hammer, plastic

Two

Handle, ratchet, 3/8-inch drive

Key, socket head screw, 1/4-inch

Equipment Condition

Pliers, long-nose, round

Riveter, hand

Pusher axle wheel removed for the side being

Screwdriver, flat-tip, 5/8-inch

repaired (TM 9-2320-270-10).

Socket, 1/2-inch, 3/8-inch drive

Wrench, box, 1/2-inch

Wrench, open-end, 5/8-inch

Wrench, open-end, 13/16-inch

Wrench, open-end, 7/8-inch

Wrench, open-end, 15/16-inch

Wrench, pipe, 1/4- to 1-inch

ACTION

REMARKS

ITEM

LOCATION

REMOVAL/DISASSEMBLY

WARNING

Make sure all pressure is drained from air system before disconnecting air lines. Parts

under pressure can, when removed, fly off with great force causing injury to personnel.

NOTE

Except as noted, the steps in this task are the same for all four pusher axle brake

chambers. Right side chambers are shown.

4-692