CLEANING/INSPECTION - TM-9-2320-270-20-20034

TM 9-2320-270-20-2

RETARDER CONTROL LINKAGE- CONTINUED

ACTION

REMARKS

ITEM

LOCATION

CLEANING/INSPECTION

Clean as shown in General Maintenance

All parts

26.

Instructions (page 4-1).

Inspect as shown in GeneraI Maintenance

All parts

27.

Instructions (page 4-1).

ASSEMBLY

Screw one on each end as far as possible.

Two nuts (2) and (3)

28. Pedal rod (1)

NOTE

There are two d ifferent ballpoints on pedal rod. One is spring loaded so that threaded end

with ball may be detached from joint. Do not tighten detachable ball joint to pedal rod.

a. Screw on as far as possible with

Non-detachable

29. Pedal rod (1) and

threaded ends at right angles to one

ball joint (4) and

two nuts (2) and (3)

another.

detachable

b. Place non-detachable balljoint (4)

ball joint (5)

in machinist's vise.

c. Using 1/2-inch open-end wrench,

tighten nut (2) against non-detachable

ball joint (4).

d. Take out of machinist's vise.

Other nut will be tightened during

adjustment.

Screw one on each end as far as possible.

Two nuts (7)

30. Connecting rod

yoke (6)

a. Screw on until yoke ends are flush

Two clevises (8)

31. Connecting rod yoke

with inside surface and alined.

(6) and two nuts (7)

b. Place one clevis (8) in machinist's

vise.

c. Using 3/4-inch open-end wrench,

tighten nut (7) against clevis (8).

d. Take of of machinist's vise.

Repeat step 31 b, c, and d for

other nut making sure clevises are

inline with one another.

INSTALLATION

Place in position.

Retarder control

32. Two plates (9)

lever (11).

and (10)

4-552