HEADLIGHT ASSEMBLY

TM9-2320-270-20-1

HEADLIGHT ASSEMBLY

This task covers:

Installation (page 4-354)

a. Removal (page 4-348)

Alinement (page 4-357)

b. Disassembly (page 4-352)

c. Assembly (page 4-352)

INITIAL SETUP

Materials/Parts Continued

Tools

Lockwasher, ground strap to grille guard

Handle, ratchet, 3/8-inch drive

(two required)

Knife, pocket

Lockwasher, ground strap to headlight bracket

Remover, wire, 0, 120-inch diameter

(two required)

Screwdriver, cross-tip, number 2

Lockwasher, headlamp bowl to bracket

Socket, 1/2-inch, 3/8-inch drive

Lockwasher, headlamp bracket to rubber

Socket, deep-well, 11/16-inch,

mounts (four required)

3/8-inch drive

Lockwashers, rubber mounts to grille guard

Square, combination

(three required)

Tape measure

String (item 17, appendix C)

Wrench, open-end, 1/2-inch

Tag, marking (item 18, appendix C)

Tape, electrical (item 20, appendix C)

Materials/Parts

Personnel Required

Chalk

Deutsch connector assembly

Three

(two required)

ACTION

REMARKS

ITEM

LOCATION

NOTE

To change lamp go to disassembly. It is not necessary to remove headlight assembly to

change lamp.

REMOVAL

NOTE

The steps in this task are the same for both the right and the left headlight assemblies.

The right headlight assembly is shown.

Tag wires according to general maintenance instructions (page 4-1).

4-348