 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM9-2320-270-20-1
WARNING AND INDICATING LAMP ASSEMBLY - CONTINUED
ACTION
ITEM
REMARKS
LOCATION
REMOVAL
CAUTION
Ignition switch must be off before changing lamp assemblies to prevent damage to
electrical system.
NOTE
Steps in this task are similar for: low oil pressure/high water temperature warning lamp
assembly; low air pressure warning lamp assembly; differential lock indicator lamp
assembly; and PTO auxiliary throttle indicator lamp assembly. Low oil pressure/high
water temperature warning lamp assembly is shown.
Tag wires according to general maintenance instructions (page 4-1).
Pull Off.
Lens assembly (2)
1. Instrument panel (1)
Open (page 4-244).
Instrument panel
2.
Pull out.
Lampholder (4)
3. Lamp body (3)
Push and turn one-quarter turn counter-
Lamp (5)
4. Lampholder (4)
clockwise and take out.
Nut (6)
Using 7/8-inch box wrench, unscrew and
5. Lamp body (3) to
take off.
instrument panel (1)
a. Take out.
Lamp body (3) and
6. Instrument panel (1)
Iockwasher (7)
b. Get rid of Iockwasher (7).
Tie wraps
a. Note number and location.
7. Wires (8)
b. Using cutting pliers, cut and take off.
c. Get rid of.
Using 3/8-inch open-end wrench, unscrew
Nut (10)
8. Lampholder (4) to
and take off.
IGN terminal (9)
Lockwasher (11)
a. Take off.
9.
b. Get rid of Iockwasher (11).
and wire (12)
Bullet plug (14)
Unplug and take out Iampholder (4).
10. Bullet
connector (13)
4-254
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals