REAR - REAR AXLE DIFFERENTIAL - CONTINUED
New gasket (2) and
Remove differential carrier (3) from
overhaul stand and support on dolly-
Apply 118-inch (3.1-mm) bead of
gasket sealant on housing (1).
Put on gasket (2).
Line up carrier (3) with housing (1)
using dolly-type jack and roll into
Use a pry bar to help straighten
carrier, but be careful not to
damage mating surfaces.
Twelve new lock-
Screw in, and tighten to 80-90 ft-lb
washers (4) and
(109-122 N m) of torque using 15/16-
inch socket and torque wrench with 1/2-