REAR-REAR AXLE DIFFERENTIAL - CONTINUED
ASSEMBLY - CONTINUED
Attach lifting cables and hoist.
Using hoist, put in position.
Tilt assembly to allow ring gear
to pass pinion gear.
Screw in handtight against bearings (4).
Four dowels (5)
Note location, and put in place.
Matchmark one cap to correct carrier
Place both caps (6) in position.
Four screws (7)
Screw in, and tighten to 150-160 ft-lb
(203-217 N m) of torque using 13/16-
inch socket and torque multiplier wrench
wrench with 314-inch drive.
Two bearing Tighten each adjuster (3) alternately, and
carrier (1) and
adjusters (3) at the same time, turn ring gear (8) using
Tighten adjusters until all end play