INTERMEDIATE DIFFERENTIAL - CONTINUED
ASSEMBLY - CONTINUED
Measure end play using dial indicator.
End play should be within 0.000 to 0.003 inch
(0.000 to 0.07 mm). while 0.000 end play for
idler shaft is allowed. It is important that
bearings not be loaded with side thrust.
If end play is not within tolerance,
the spacer (11) must be changed.
End play can be reduced by installing a
thinner spacer and increased by installing a
thicker spacer. Use micrometer to measure
spacer thickness and make new selection
If spacer (4) must be changed, go back
to DISASSEMBLY, step 11.
If end play is within tolerance, go to step 30.