INTERAXLE DIFFERENTIAL - CONTINUED
Power divider inter-
Place container underneath to catch
mediate case (1)
Using 1/2-inch drive ratchet handle,
unscrew and take out.
Allow oil to drain.
Get rid of oil (page 2-46).
Four screws (5)
Using 3/8-inch drive-pin punch and
cap (3) and lower
and two lock-
2-lb ball-peen hammer, flatten tabs.
bearing cap (4)
Using 9/16-inch socket and ratchet
handle with 3/8-inch drive, unscrew
and take out.
Get rid of lockplates (6).
Place hydraulic jack under propeller
shaft (8) near yoke (7), and place
wood block between.
Using hydraulic jack, carefully raise
shaft (8) until cap (3) is forced out
of yoke (7).
Using angle-nose slip-joint pliers,
gently twist out cap (3).
Place wood block against yoke finger
(9) and with 2-lb ball-peen hammer,
strike sharply to force out cap (4).
Make sure you strike evenly so cap does not
jam in yoke.
Mating yoke (10)
Tip universal cross and slide out.
Carefully set propeller shaft (8)