FORWARD-REAR AXLE DIFFERENTIAL - CONTINUED
INSTALLATION - CONTINUED
102. Forward-rear axle
New gasket (6)
Put in position.
and output shaft
(7) with bearing
Four new lock-
Using 9/16-inch socket and torque wrench
washers (9) and
with 1/2-inch drive, screw in and tighten
to 30 - 40 ft-lb (41 - 54 N m) of torque.
104. Yoke (11)
Propeller shaft (12)
a. With help from assistant, put in
position and support with hydraulic
b. Tip universal cross (13) forward and
slide yoke (14) into yoke (11).
Upper bearing cap
Using 3-lb ball-peen hammer and wood
(15) and lower
block, tap sharply into place.
bearing cap (16)
106. Upper and lower
Two new locking
Put on plates (17).
plates (17) and
Using 9/16-inch socket and ratchet
(15) and (16)
four screws (18)
handle with 1/2-inch drive, screw in
and tighten screws.
Using 3-!b ball-peen hammer and
3/8-inch drive-pin punch, bend up
lock plate tabs.
Remove hydraulic jack.