 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-269-34-1
FORWARD-REAR AXLE DIFFERENTIAL - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
ASSEMBLY - CONTINUED
87.
Differential
Ring gear (2)
To set bearing preload, mount dial indi-
carrier (1)
cator at side of gear (2).
88.
Two bearing
Four screws (4)
Unscrew only enough to note end play on
caps (3)
indicator using 13/16-inch socket and
ratchet handle with 1/2-inch drive.
89.
Differential
Ring gear (2)
a.
While gear (2) is held at zero end
carrier (1)
play, and before loading bearings,
check runout by turning ring gear (2).
b.
If runout is more than 0.008-inch
(0.20 mm), remove differential
assembly and check for cause.
90.
Two bearing
Four screws (4)
a.
Tighten to 150 - 160 ft-lb. (203 -
caps (3)
217 N m) or torque using 13116-inch
socket and torque wrench with 112-inch
drive.
b.
Recheck backlash, see step 81.
91.
Two adjuster
Put in.
locks (5)
92.
Two adjuster
Two new cotter
a. Put in.
locks (5)
pins (6)
b. Separate ends and bend back using
angle-nose slip-joint pliers.
TA238531
2-868
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals