TRANSMISSION SELECTOR LEVER AND SHIFT LINKAGE - CONTINUED
CLEANING - CONTINUED
All metal parts
Clean in drycleaning solvent.
Dry with compressed air.
For more information on how to inspect parts, go to General Maintenance Instructions (page 2-46).
Replace damaged or defective parts, as needed.
ASSEMBLY AND INSTALLATION
Oil pan (1)
Two spacers (2) and
Put in position.
Two screws (4)
Tighten until snug using 1/2-inch
socket, ratchet handle with 112-inch
drive, and 6-inch extension.
Tighten to 10-13 ft-lb (13.6-17.6 N m)
of torque using 1/2-inch socket, 6-
inch extension, and torque wrench with
Control cable (5)
Screw on until against nut (7) using
angle-nose slip-joint pliers and wrench
Tighten against swivel (6) using 1/2-
inch open-end wrench.
Three washers (9)
and shift lever(10)