 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-269-34-1
FORWARD CLUTCH AND TURBINE SHAFT - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
ASSEMBLY - CONTINUED
36.
Piston (1)
Bearing race (2),
a.
Place clutch housing and shaft on a
roller bearing
clean workbench.
assembly (3),b.
Lubricate races and bearing with oil
and bearing
soluble grease.
race (4)
Use enough grease to hold races and
bearing in place to prevent damage
to bearing while clutch is being
assembled.
c. With outer lip first, place bearing
race (2) in position.
d. Put roller bearing assembly (3) in
position.
e. Put bearing race (4) in position.
37.
Forward clutch
Place in position.
hub (5)
38.
Forward clutch
Five external tanged
Put an external tanged plate in position
hub (5)
clutch plates (6)
followed by an internal splined plate
and five internal
until all 10 clutch plates are in place.
splined clutch
plates (7)
39.
Ten clutch plates
Fourth clutch
Place in position.
(6) and (7)
driving hub (8)
40.
Snapring (9)
Using 1/4-inch flat-tip screwdriver, put
in.
41.
Forward clutch
Snapring (11)
Using snapring pliers, put on.
housing and turbine
shaft (10)
42.
Power takeoff
From rear of clutch housing, with cham-
gear (12)
fered inside diameter first, and using
3/8-inch flat-tip screwdriver, slide into
position over snapring while prying up on
snapring.
43.
Roller bearing
a.
Lubricate with oil soluble g rease.
race (13)
b.
Place in position at base of shaft (10).
44.
Roller bearing (14)
a.
Lubricate with oil soluble grease.
b.
Place in position at base of shaft (10).
2-746
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals