TORQUE CONVERTER - CONTINUED
ASSEMBLY - CONTINUED
Ten rollers (2)
a Place stator (1) with bearing side down
and springs (3)
b. Cover bottom of stator cam pockets with
oil soluble grease.
c. Install stator roller retainer ring.
d. Put rollers (2) and springs (3) in
Ends of springs that touch
roller must point toward center of
a. Put in place, bearing side down.
b. Turn clockwise while pressing down
until it touches retainer tool.
c. Lift up stator (1) and remove stator
roller retainer ring.
d. Set down stator and press down on race
(4) until it is firmly seated .
e. Turn race (4) firmly counterclockwise
to lock it.
With roller race down and held in position,
place on hub.
Put in place.
Do not install the thrust bearing spacer at this time.
Put in place with outer lip up.
Grease, and put in place.
New packing (10)
a Line up balance mark with mark on
impeller assembly (5).
b. Put in position.