TORQUE CONVERTER - CONTINUED
DISASSEMBLY - CONTINUED
Bearing (2) and
Eight screws (4)
a. Using ball-peen hammer and 1/2-inch
and four lock-
cold hand chisel, flatten tabs.
b. Using 7/16-inch socket, 3-inch exten-
sion, and ratchet handle with 1/2-inch
drive, unscrew and take out.
c. Get rid of lockplates (5).
Hub (1) and
a. Using rubber hammer, tap loose and
b. Get rid of gasket (7).
For more information on how to clean parts, go to General Maintenance Instructions (page 2-46).
Solvent burns easily. Solvent fumes can explode. Do not smoke or allow open flame nearby when
using solvent. Failure to observe these precautions could cause serious injury or death.
All metal parts
a. Clean in drycleaning solvent.
b. Wipe dry with clean, dry rags.