TRANSMISSION SUBASSEMBLIES - CONTINUED
GOVERNOR ASSEMBLY INSTALLATION - CONTINUED
Governor cover (1)
Four screws (2)
a. Screw in until snug, using ½-inch
socket and ratchet handle with ½-
b. Using ½-inch socket and torque
wrench with ½-inch drive, tighten
to 15-20 ft-lb (20.3 - 27.1 Nm) of
FIRST RANGE CLUTCH INSTALLATION
Using 3/8-inch flat-tip screwdriver and
plate snapring (4)
12-inch pry bar, take out.
a Using 9/16-inch socket and ratchet
screw (5) and
handle with 1/2-inch drive, unscrew
and take out.
b. Get rid of lockwasher (6).
Remove (page 2-650).
plates (7), three
clutch plates (8),
and backing plate (9)
Thrust washer (10)
Place into position.