FUEL INJECTORS - CONTINUED
ASSEMBLY - CONTINUED
Repeat steps 12 and 13.
If opening pressure is not 2800 +
50 psi (19306 + 344 kPa),
repeat steps 14 thru 17 and add or
remove adjusting shims to raise or
lower opening pressure as needed.
If spray pattern is irregular, repea t
steps 14 thru 24.
If adjustment or cleaning was needed,
repeat steps 25 thru 29.
Solvent burns easily. Solvent fumes can explode. Do not smoke or allow open flame nearby when
using solvent. Failure to follow these precautions could result in serious Injury or death.
The Injector must seat flush for proper operation. Do not clean mating surfaces with tools.
Cylinder head (11)
Injector bore (12)
a Take off rag.
b Wipe clean with clean ra gs dampened
with drycleaning solvent.