REMOVAL - CONTINUED
Cylinder head (1)
a. Take off.
(2) and four
b. Get rid of gaskets (3).
Using 3/8-inch open-end wrench, un-
screw and take out.
For more information on how to clean parts, go to General Maintenance Instructions (page 2-46).
Solvent burns easily. Solvent fumes can explode. Do not smoke or allow flame nearby when
using solvent. Failure to observe these precautions could cause serious injury or death.
All metal parts
a. Clean in drycleaning solvent.
b. Wipe dry with clean, dry rags.
For more Information on how to inspect parts, go to General Maintenance Instructions (page 2-46).
Replace damaged parts as necessary.
Look for cracks, breaks, and dents.
Screw in, and tighten using 3/8-inch