 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-269-34-1
CAMSHAFT - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
ASSEMBLY - CONTINUED
19.
Cover plate (1) Three new lock-
Screw in, and tighten, using 9/16-inch
washers (2) and
socket and handle with 1/2-inch drive.
screws (3)
INSTALLATION
20.
Cylinder block (4)
Camshaft (5) with
a. Install remover/installer tool on the
attached parts
camshaft threads.
b. Lubricate lobes, journals, and bearings
with clean engine oil.
c. Put in position in block (4).
21.
Camshaft (5)
Two screws (6)
a. Screw in until snug using 9/16-inch
socket and ratchet handle with 1/2-
inch drive.
b. Using 9/16-inch socket and torque
wrench with 1/2-inch drive, tighten to
40 - 50 ft-lb (54 - 61 N m) of torque.
22.
Spacer (7) and
a. Screw in until snug using 1 7116-inch
nut (8)
impact socket and ratchet handle with
3/4-inch drive.
b. Using 1 7/16-inch socket and torque
wrench with 3/4-inch drive, tighten to
200 - 225 ft-lb (271 - 305 N m) of
torque.
23.
Crankshaft (9)
Nut (10)
a. Using 2-inch open-end wrench, screw
on and tighten.
b. Using 2-inch open-end wrench, rotate
crankshaft (9) to see that timing gears
do not bind.
If gears bind, go back to removal,
take out camshaft, and check for
correct assembly of parts.
c. Using 2-inch open-end wrench,
unscrew and take off.
24.
Cylinder block (4)
Camshaft (5)
Using dial indicator, check end play.
End play must be 0.0035 to 0.0115
inch (0.089 to 0.292 mm).
2-188
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals