CYLINDER HEAD COVER ASSEMBLY - LEFT SIDE
This task covers:
Removal (page 2-180)
c. Inspection/Replacement (page 2-181)
Cleaning (page 2-180)
d. Installation (page 2-181)
Screwdriver, flat-tip, 3/8-inch
Gasket, cylinder head cover
Power steering pump and bracket removed
Rags, wiping (item 42, appendix B)
Solvent, drycleaning (item 49,
1. Cylinder head
Ten screws (2) and
Using 3/8-inch flat-tip screwdriver,
unscrew and take out.
2. Cylinder head (4)
Cylinder head cover
a. Take off.
(1) and gasket (5)
b. Get rid of gasket (5).
For more information on how to clean parts, go to General Maintenance Instructions (page 2-46).
Solvent burns easily. Solvent fumes can explode. Do not smoke or allow open flame nearby when using solvent.
Failure to observe these precautions could cause serious injury or death.
a. Clean in drycleaning solvent.
b. Wipe dry with clean, dry rags.