PISTONS AND CONNECTING RODS - CONTINUED
REMOVAL - CONTINUED
Write down beari ng-to-journal
If clearance Is not within
0.0019-0.0044 Inch (0.048-0.112
mm), upper and lower bearing
(5) and (7) must be replaced.
If plastic gage is wider at one end
than at the other, the difference be-
tween measurements at each end is
approximate bearing-to-journal clear-
Bearing cap (3)
Roll out, tang end first.
Keep each bearing cap and shell
together for proper placement
Cylinder block (4)
Piston (5) and
Push out through top.
connecting rod (6)
Piston and rod assembly will not come
with attached parts
out from bottom of block.