INSTALLATION - CONTINUED - TM-9-2320-269-34-10145

TM 9-2320-269-34-1

CRANKSHAFT AND MAIN BEARINGS - CONTINUED

ACTION

LOCATION

ITEM

REMARKS

INSTALLATION - CONTINUED

46.

Crankshaft (1)

Crankshaft pulley

Screw on, and tighten using 2-inch open-

nut (2)

end wrench.

NOTE

Connecting rods and their caps are numbered for proper placement.

All connecting rod bearing caps are installed the same way. Repeat steps 47 thru 49 for each cap.

47.

Connecting rod (3)

Using 2-inch open-end wrench, turn crank-

and attaching parts

shaft until rod (3) is lined up with rod

journal.

48.

Connecting rod (3)

Connecting rod

Make sure cap (4) is the correct one

and crankshaft (1)

bearing cap (4)

for location.

with lower bearing

Using plastic-face hammer, tap into

shell (5)

place.

49.

Connecting rod

Two nuts (6) and

Screw on until snug using 11116-inch

bearing cap (4)

washers (7)

socket and ratchet handle with 1/2-

inch drive.

Tighten to 53 - 57 ft-lb (72 - 77 N m)

of torque using 11/16-inch socket and

torque wrench with 1/2-inch drive.

Release torque load to zero.

Using 11/16-inch socket and ratchet

handle with 1/2-inch drive, tighten.

Tighten again to 53 - 57 ft-lb

(72 - 77 N m) of torque using 11/16-

inch socket and torque wrench with

1/2-inch drive.

Using 11/16-inch socket and ratchet

handle with 1/2-inch drive, turn each

nut (6) an additional one-sixth turn,

or one flat of the nut (6).

50.

Crankshaft (1)

Woodruff key (8)

Using ball-peen hammer, tap in.

51.

Crankshaft timing

Apply clean engine oil to inside

gear (9)

diameter.

Line up keyway and timing mark.

2-128