Rifle, Cal. .30, M1, M1C (Sniper's) and TM 9-1005-222-
This chapter provides instructions on direct support
35 MID (Sniper's)
procedures for repairing or reinforcing wooden, fiber
Rifle, 7.62-MM, M14 and M14A1
glass / plastic or plastic components.
Rifle, 5.56-MM, M16 and M16A1
Launcher, Grenade, 40-MM, M79
Groups or assemblies will be disassembled in
Selection of Type of Repair or Reinforcement
accordance with applicable publications listed below:
Selection of the type of repair or reinforcement to
be used for unserviceable components must be made on
Carbine, Cal..30, M1 and M2
an item basis, when the weapon is inspected at the direct
Rifle, Cal..30, Automatic Browning,
support maintenance shop.
Section II. REPAIR OF WOODEN COMPONENTS
The repair of wooden components by using
damaged area will require the use of epoxy adhesive,
brass reinforcing screws and / or epoxy adhesive is
reinforcing screws or both.
authorized at direct support maintenance. The small
arms repairman will determine if the
Non-Repairable Areas Refer to figure 3-1.