REPLACE J-SIIDS LEDA INTERFACE ASSEMBLY (Hinged)

TM 5-6350-275-24&P

3-91.

REPLACE J-SIIDS LEDA INTERFACE ASSEMBLY (Hinged). (See Figure 3-46).

This task consists of:

a. Remove

b. Install

INITIAL SETUP

Equipment Condition:

General Safety Instructions:

Input power removed

Remove all jewelry while working on

Enclosure access cover removed

equipment.

Wear ESD wriststrap while working on

Tools:

equipment.

Screwdriver, Flat tip, (Item 7, App B)

Materials/Parts:

J-SIIDS Leda Interface Assembly (Hinged)

WARNING

Shut off power source before attempting to disconnect, service, or connect wires or cables.

Failure to do so may result in serious injury or death.

a. Replace

(1) Tag and remove the slip-on terminal strip from the Leda Flex PWA (3) TB-7 (4).

(2) Tag and remove slip-on terminal strips from Leda Flex Termination PWA (1) TB-1, TB-2, TB-3, TB-4, TB-

5, TB-6 (11), TB-7 (10), and TB-8 (9) by gently lifting up on sides of terminal strips.

(3) Using a flat tip screwdriver, remove screw (8), and lower the hinged panel assembly (5).

(4) Using a flat tip screwdriver, remove the two screws (6) holding the J-SIIDS Leda Interface Assembly (5) to

the J-SIIDS enclosure (12) and remove.

b. Installation

(1) Align the J-SIIDS Leda Interface Assembly (5) up with the two J-SIIDS enclosure standoffs and secure the

Assembly with two screws (6).

(2) Raise the hinged panel assembly (5) and secure to J-SIIDS enclosure (12) with screw (8).

(3) Using a flat tip screwdriver, connect the tagged wires to TB-1 through TB-6 (11), TB-7(10) and TB-8 (9).

(4) Connect the tagged slip-on terminal strip to Leda Flex PWA (3) TB-7 (4).

(5) Reconnect input power.

(6) Close, lock and secure the J-SIIDS enclosure door.

3-179