Section II. TROUBLESHOOTING PROCEDURES

TM 5-6350-275-10

Section I. LUBRICATION INSTRUCTIONS.

There are no lubrication requirements associated with ICIDS.

Section II. TROUBLESHOOTING PROCEDURES.

3-1 SCOPE.

a. Table 3-1 lists common malfunctions that you may find. Perform the tests, inspections, and corrective actions in

the order in which they appear in the table.

b. The table cannot list all the malfunctions that may occur, all the tests and inspections that may be needed to find

the fault, or all the corrective actions that may be needed to correct the fault. If the equipment malfunction is not listed or

actions listed do not correct the fault, notify your supervisor.

Table 3-1. Common Malfunctions

Malf

Observed Problem

Probable Cause

Solution

Index

Workstation will not power up.

Power cables or power supplies

Reseat all cables and

disconnected or not properly

apply power.

seated at either the workstation

If problem persists notify

or power source.

supervisor and contact

next higher maintenance

level.

Workstation powers off by

Power cables or power supplies

Reseat all cables and

itself.

not properly seated at either the

apply power.

workstation or power source.

If problem persists notify

supervisor and contact

next higher maintenance

level.

Monitor screen is dark.

ON/OFF switch is in OFF

Place switch to ON.

position.

Brightness control is off.

Operate brightness

control.

Video cable not properly seated.

Reseat cable.

If problem persists notify

supervisor and contact

next higher maintenance

level.

3-3