CHAPTER 1 INTRODUCTION - TM-5-6350-262-14-10009

TM 5-6350-262-14/1

NAVELEX 0967-LP-466-9012

TO 31S9-4-36-1 Chg 2

CHAPTER 1

INTRODUCTION

Section I. GENERAL

Forms) and/or DA Form 2028-2

(Recommended

1-1. Scope

Changes to Equipment Technical Manuals located in the

back of the manual mail the forms (direct to

a. This manual describes Processor, Ultrasonic

Commander, US Army Troop Support Command,

Motion Signal MX-9444( )/FSS-9(V) and Transceiver,

ATTN: AMSTS-MPP, 4300 Goodfellow Blvd, St. Louis,

Ultrasonic Motion Signal RT-1161( )/FSS9(V) (fig. 1-1)

MO 63120. A reply will be furnished direct to you.

and provides instructions for installation, operation, and

maintenance at Organizational, Direct Support, and

b. For Air Force personnel, reporting of errors,

General Support maintenance levels. In this manual,

omissions, and recommendations for improving these

Processor, Ultrasonic Motion signal MX-9444( (/FSS-

publications should be submitted on Form 22 and

9(V) is referred to as processor and Transceiver,

forwarded to HQ, SAMMA/MMSTR, Kelly AFB, Texas

Ultrasonic Motion Signal RT-1161( )/FSS(V) is referred

78241.

to as transceiver. The two units together are referred to

as processor/ transceiver ultrasonic motion signal.

For Navy personnel, reporting of errors,

omissions and recommendations for improving this

b. The units covered in this manual operate with

publication should be submitted on Technical Manual

Joint Services Interior Intrusion Detection System (J-

User Activity Comment Sheet and forwarded to Naval

SIIDS). For overall system operation, installation, and

Elect Systems Command, National Center Building 1,

interconnections, refer to TM 5-6350-262-14/14.

ATTN: ELEX-4903, Washington, DC 20360.

c. Appendix A lists the publications applicable to

1-5. Destruction of Army Material to Prevent

this equipment. Appendix B contains the Maintenance

Enemy Use

Allocation Chart, and appendix C contains the Repair

Parts and Special Tools List.

When ordered by the commanding officer, proceed with

the destruction of equipment in the order of priority

1-2. Maintenance Forms and Records

according to the prescribed methods outlined in

Procedures for Destruction of Equipment to Prevent

a. Reporting of Maintenance and Unsatisfactory

Enemy Use, TM 750-244-3. The order of priority for

Equipment.

Department of the Army forms and

destruction of material is all instruction manuals,

procedures used for equipment maintenance will be

transceivers, processors, and all spares on hand.

those prescribed by TM 38-750.

Randomly cut all Interconnecting cables.

Reporting of Packaging and Handling

1-6. Administrative Storage

Deficiencies. Fill out and forward AFR 71-4 (Air Force).

For procedures, forms and records, and inspection

c. Discrepancy in Shipment Report (DISREP).

requirements

during

administrative

storage

Fill out and forward AFM 75-34 (Air Force).

equipment, refer to TM 740-90-1.

1-3. Equipment Serviceability Criteria (ESC). This

1-7. Calibration

equipment is not covered by an ESC.

The processor/transceiver ultrasonic motion signal does

1-4. Reporting of Errors

not require calibration.

You can improve this manual by

recommending improvements using DA Form 2028

(Recommended Changes to Publications and Blank

Change 2 1-1