c. Replacement of Tail Light Lamps.
(4) Insert and secure new bulb. This is a
double filament bulb and the base in indexed for proper
installation. Always use recommended bulb. Do not
(1) Engage detent in retaining ring with a
screw driver and pry the retaining ring out.
(5) Replace lens.
(2) Remove lens.
(6) Replace retaining ring.
(3) Remove burned out or broken bulb.
Section X. MAINTENANCE OF CABLE REELS
Instructions contained in this section are for operators
information and guidance in maintenance of cable
3-39. Cable Reels
a. Inspect the drums for cracks, chips, dents, and
a. Inspect all primary and secondary cables for
b. If drums are found to be unserviceable report
worn insulation, breaks or cracks and that splices are
your findings to organizational maintenance.
3-40. Shaft Bearings
b Inspect end terminals to see if they are intact,
clean and bright.
a. Check that bearings rotate freely.
c. Replace badly worn or unserviceable cables.
Clean dirty end terminals.