Marking. - TM-43-01560187

TM 43-0156

Step

Function

Mech

Insp

(d) Wrap the arc chutes with PPP-C-843 cushioning.

cont

(e) Place arc chutes into the box.

(f) Isolate the arc chutes from the sides of the box

and each other by using MM-L-751 lumber (21 x 2 x

4) and seal the box.

(g) Mark box to indicate contents.

(h) Secure the relay covers with QQ-W-461 wire.

(i) Coat electrical contacts and terminals with

MIL-C-83360 coating compound.

(j) Secure circuit breaker control door with QQ-W-461 wire.

(k) Install protective blocking MM-L-751 lumber

(25-1/2 x 2 x 4) (17 x 2 x 4) (5-3/4 x 2 x 4)

inside the switch gear cubicle between the relay

panel and exterior access door.

(l) Remove plastic vents from doors. Put screws back

into holes.

(m) Wrap vents in PPP-C-843 cushioning and place into

a PPP-B-636 fiberboard box (12 x 8 x 6). Seal box

lid with PPP-T-76 tape.

(n) Secure box inside cabinet with MIL-T-22085 tape.

PPP-T-60, type 4, 4-inch wide tape, may be used

as a substitute.

(o) Secure the door handles with a positive locking device.

(p) Seal openings with MIL-T-22085 tape. PPP-T-60

tape may be used as a substitute.

(2) Cable Reels. Place each cable reel--900-ft control

cable, 900-ft power cable, and 300-ft ground cable--

into a PPP-B-601 box fabricated in accordance with

appendix D-1. Refer to tables B-3-13, B-3-14, and

B-3-15 for a list of materials. Mark box to

identify contents.

f. Marking.

(1) Mark boxes and units in accordance with appendix E.

(2) Mark four sides of the containers with 2-inch

minimum size letters to indicate "REUSABLE CONTAINER

- DO NOT DESTROY."

Change 1

B-3-34