Electrolyte.

TM 43-0156

Step

Function

Mech

Insp

(4)

Ground Rods. Place ground rods in a PPP-B-601 box

cont

(75-1/2 x 4-1/4 x 4-1/4) fabricated in accordance

of materials. Mark box to identify contents.

(5)

Aspirator Gaskets. Tape each gasket to a piece of

PPP-F-320 fiberboard (32 x 32). Place gaskets in a

fiberboard box (32-1/4 x 32-1/4 x 2). Seal box with

PPP-T-76 tape. Mark box to identify contents.

(6)

Fluorescent Lamps. Cushion lamps with PPP-C-843

cushioning and secure in place with PPP-T-60 tape.

(7)

Electrolyte.

(a) Fabricate a PPP-B-601 box (58-1/2 x 32-1/4 x

21-1/4) in accordance with appendix D-1. Refer to

table B-3-6 for list of materials.

(b) Fill bottom of box with 3 inches of HH-I-585

thermal insulation.

inches between each container on top of the

insulation.

(d) Fill void with HH-I-585 thermal insulation to the

level of the top edge of the wooden box.

(e) Close and secure box lid and mark box to identify

contents.

(8)

Electrical Fittings.

(a) Place the 12 bolt-on terminals in a MIL-B-131 bar-

rier bag (12 x 12) and heat seal. Mark bag to

identify contents.

(b) Place the 10 copper split-bolt connectors in a

MIL-B-131 barrier bag (12 x 12) and heat seal.

Identify bag contents.

barrier bag (12 x 20) and heat seal. Mark bag to

identify contents.

(d) Place the 500 nylon female quick disconnect termi-

nals in a MIL-B-131 barrier bag (20 x 25) and heat

seal. Mark bag to identify contents.

B-3-17