Packing for the Air Receiver Tank.

TM 43-0156

Step

Function

Mech

Insp

Packing for the Air Receiver Tank.

cont

(1) Fabricate a MIL-B-26195 box (70-1/2 x 46 x 43-1/2)

in accordance with appendix D-2. Refer to table

B-2-7 for a list of materials.

(2) Cover base with MIL-B-121 barrier.

(3) Mount air receiver tank on base and secure with 1/2-

x 4-1/2-inch FF-B-584 bolts, NN-W-902 washer, and

FF-N-92 nuts. Refer to figure B-2-5 for location of

blocking.

(4) Place crate top over air receiver tank and secure to

base with FF-W-92 washer and FF-B-561 lag bolts (3/8

x 3-1/2).

(5) Mark container in accordance with appendix E and the

following: Mark all four sides of the container

with 2-inch minimum size letters to indicate

"REUSABLE CONTAINER - DO NOT DESTROY."

Battery Jumper Cables.

(1) Coat cable connectors with MIL-S-8660 silicone.

Wrap with MIL-B-121 barrier and secure with PPP-T-60

tape.

(2) Place in a PPP-B-636 fiberboard box (16 x 6 x 4).

Seal box with PPP-T-76 tape.

(3) Pack with the power and control cables.

Preservation of the Exhaust Pipes, Elbows, and Silencers.

(1) Atomize spray interior surfaces of exhaust pipes,

elbows, and silencers with MIL-L-21260, type I,

grade 30 preservative oil.

(2) Tape off ends with MIL-T-22085 tape. PPP-T-60 tape

may be used as a substitute.

Packing for the Exhaust Pipes for 1500 KW.

(1) Fabricate a MIL-C-104 crate (158 x 55 x 45) and

cradles in accordance with appendix D-3 and figure

B-2-6. Refer to table B-2-8 for a list of materials.

Change 1

B-2-30