Louvered Radiator Openings (sides) (two).

TM 43-0156

Step

Function

Mech

Insp

(3)

Cover louvers with MIL-B-131 barrier and NN-P-530,

5/16-inch plywood panel (104 x 103). Drill holes in

panel in the location of missing mounting bolts. NN-

cont

P-530, 3/8-inch plywood, may be used as a substitute.

(4)

Secure plywood panel with removed bolts.

Seal edges

of plywood panel with MIL-T-22085 tape.

PPP-T-60,

type 4, 4-inch wide tape, may be used as a substitute.

Louvered Radiator Openings (sides) (two).

(1)

Close louvers.

(2)

Remove 12 bolts (evenly spaced) from around louvers

to secure a plywood panel.

(3)

Cover louvers with MIL-B-131 barrier and NN-P-530,

5/16-inch plywood panel (86-1/2 x 55-1/2. Drill

holes in location of mounting bolts that were

removed. NN-P-530, 3/8-inch plywood, may be used

as a substitute.

(4)

Secure plywood panel with removed bolts.

(5)

Seal edges of plywood panel with MIL-T-22085 tape.

PPP-T-60, type 4, 4-inch wide tape, may be used as

a substitute.

Catwalk, Clevises, Exhaust Stacks, Ground Rods, Wire,

and Clamps.

(1)

Secure catwalk in its raised position.

(2)

Secure exhaust clamps to exhaust stacks.

(3)

Secure exhaust stacks, clevises, and ground rods to

the catwalk using QQ-S-781 steel strapping. Isolate

the steel strapping with fiberboard. Secure

strapping with QQ-S-781 seals.

Slings. Coat slings with MIL-C-16173, grade 1 corrosion

preventive compound.

Bracing for Shipment.

(1)

Air Filter Compartment. Place MM-L-751 lumber (36 x

2-7/8 x 4) between air filter compartments and the

generator control cabinet.

(2)

Control Cabinet. Brace the generator control

cabinet to the generator with QQ-S-741, 3-inch angle

iron. Bolt brace in place with existing bolts and

lifting eyes on generator.

Change 1 B-1-13