Entrance, Protective, Pressurizsd, Collapsi- ble: M10 and M12.

a. Priorities for Destruction:.

(2) M7 protective entrance (fig 3-23). Tape

(1) Control module

charge to door-tensioning assembly.

(2) Fabric enclosure and frame

b. Preferred Method of Destruction. Mechanical

means, demolition, and fire.

NOTE

c. Mechanical Means. See paragraph 2-8.

d. Demolition (para 2-11). Place 1/4-pound

Entrance may be either collapsed or erected as

charges on door, in each air duct port, and on

shown.

control module inside entrance port (fig 3-24).

Detonate charges at the same time.

NOTE

If entrance is collapsed, place 2-pound charge

on top.

Figure 3-23. Explosive Charge Location for

M7 Protective Entrance - M10 Collective

Protection Equipment (HAWK).

e. Fire (para 2-14).

(1) Fasten two incendiary grenades at or

above each location specified for charges

above.

(2) Ignite grenades by using lanyards.

3-20. Entrance, Protective, Pressurizsd, Collapsi-

ble: M10 and M12.

Figure 3-24. Explosive Charge Locations for

M10/M12 Protective Entrance.

When using demolition or fire as a method of

destruction for chemically contaminated equip-

ment (alarms, filters, etc.) personnel should

e. Fire (para 2-14). Fasten incendiary grenade at

mask and move upwind of the site. if unable to

each location specified for charges above and

move upwind of the site, personnel must wear

ignite by using lanyards.

protective clothing and masks.

3-13