Quantcast  Terminal Board TB2 Component Replacement

 

Click here to make tpub.com your Home Page

Page Title: Terminal Board TB2 Component Replacement
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

Share on Google+Share on FacebookShare on LinkedInShare on TwitterShare on DiggShare on Stumble Upon
Back
Figure 5-17. Terminal Board TB2 Component Locations
Up
TM-32-5865-218-24-P Countermeasures Panel Indicator ID-2300/ALQ-151(V) and Countermeasures Control C-11124/ALQ-151(V) Manual
Next
Terminal Stud E1 through E5 Removal and Replacement.
TM 32-5865-218-24&P
(7) Replace top cover in accordance with paragraph 5-12a.
p.  Terminal Board TB2 Component Replacement.  Refer to figure
5-17 unless otherwise indicated and proceed as follows:
Remove top cover in accordance
(1) Refer to figure 5-13.
(2)
Refer to figure 5-13.  Remove TB2 (30) in accordance with
Do not remove wiring to terminal board.
Remove and replace defective component.
(3)
(4) Replace TB2 in accordance with paragraph 5-12o.
(5) Replace top cover in accordance with paragraph 5-12a.
Refer to section V of this chapter.
(6)
Refer to figure 5-13 and
q.  Relay TB2K1 Removal and Replacement.
figure 5-17, and proceed as follows:
Remove top cover (2) in accordance with paragraph 5-12a.
(1)
Remove terminal board TB2 (30) from side of chassis in
(2)
accordance with paragraph 5-12o.  Do not remove wiring
from terminal board.
(3)
Remove heatshrink tubing, then tag and remove wires
connected to TB2K1.
(4)
Remove two screws (2), flat washers (3), lock washers (4),
and nuts (5) (see figure 5-10C, items 2 thru 5) that
secure relay K1 (1) to terminal board TB2.
To replace relay K1, secure K1 to TB2 with two screws
(5)
(2), flat washers (3), lock washers (4), and nuts (figure
5-17, items 2 thru 5).
Place length of 0.125 ID black heatshrink tubing (item 12,
(6)
App. D) over each wire, then solder wires to relay ter-
minals as tagged during removal.  Slide heatshrink tubing
over connection and shrink.
Replace terminal board TB2 to side of chassis in accor-
(7)
dance with paragraph 5-12o, and top cover in accordance
Refer to section V of this chapter.
(8)
Refer to figure
r.  Relay K1, K2, or K3 Removal and Replacement.
5-13 and proceed as follows:
(1) Remove top cover (2) in accordance with paragraph 5-12a.

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business